(8.D.2.5) UpdateSampleRate
Overview
Updates the sample rate of each module wire in the system
Discussion
The module is designed to update the sample rate of all the wires in the system.
Attach the input pin of this module to the HW input pin of the AWD.
At build time, the module will build an array containing the sample rate information for each wire in the system. The .sampleRate parameter can be updated while in either design mode or in tuning mode.
This module's set function will recalculate the sample rate for each wire in the system using the formula [new wire SR] = [wire SR] * (.sampleRate / [HW pin SR]) After the wires have been updated, the module then calls the set function for each module. This will cause each module to recompute its derived variables.
Because the .sampleRate variable can be updated either manually or from the firmware using control I/O an output pin is provided to indicate when updating all the wire sample rates is complete When the .sampleRate variable is changed the output is set to 1. When all wire sample rates are changed and each module's set function is called (i.e. the change is complete) the output is set to 0. This can be used to mute the output of the system using a MuteUnmute module.
Note that this module does not change the target sample rate
In the typical use case, when the sample rate of the running target changes it causes the target firmware to use Control I/O to change the .sampleRate variable thus allowing the running layout to match processing to the new sample rate running on the target
Type Definition
typedef struct _ModuleUpdateSampleRate
{
ModuleInstanceDescriptor instance; // Common Audio Weaver module instance structure
FLOAT32 sampleRate; // Desired sample rate
FLOAT32 initialSampleRate; // Default sample rate of the system. Updated during the construction time.
INT32 updateActive; // Flag to control the state of the boolean output pin.
FLOAT32* wireSR; // Array of all modules wire sample rate info
} ModuleUpdateSampleRateClass;
Properties
Name | Type | Usage | isHidden | Default value | Range | Units |
sampleRate | float | parameter | 0 | 48000 | Unrestricted | Â |
initialSampleRate | float | state | 1 | 48000 | Unrestricted | Â |
updateActive | int | state | 1 | 0 | 0:1:1 | Â |
wireSR | float* | state | 1 | [1 x 1] | Unrestricted | Â |
Pins
Input Pins
Name: dummy
Description: Attach to system input pin
Data type: {float, int, fract32}
Channel range: Unrestricted
Block size range: Unrestricted
Sample rate range: Unrestricted
Complex support: Real
Output Pins
Name: updateActive
Description: Boolean indicating that sample rates are being updated
Data type: int
MATLAB Usage
File Name: update_sample_rate_module.m
M=update_sample_rate_module(NAME)
This module updates the sample rate information within wires and then
then calls the set function for each module. It can be used to
implement real-time sample rate changes. Arguments:
NAME - name of the module.
Â