Overview

Multiband graphic equalizer

Discussion

This subsystem implements a complete multiband graphic equalizer. The number of bands and filter order is specified at instantiation time. The subsystem consists of a cascade of individual band pass filters.

The subsystem supports floating-point and fract32 data. The data type to use is specified at instantiation time. For floating-point data, the subsystem using the graphic_eq_band_module.m module. For fract32 data, the subsystem using the graphic_eq_band_fract32_module.m module. See these modules for additional details.

The upper and lower band edges of the bandpass filter modules are set to logarithmic spacing between the center frequency values, with the low edge and high edge variables affecting the first and last module, respectively. If you change the low or high edge variable and want to reset the center frequency variable array, you will need to modify the nbands argument to reinitialize values in the center frequency variable array. These default values can be overridden after the subsystem has been created. Please note that if you change any of these defaults, the inspector will not update until a prebuild of the system has taken place.

Type Definition

-Not Shown-

Variables

Properties

Name	Type	Usage	isHidden	Default value	Range	Units
lowEdge	float	parameter	0	31.25	0:16000	Hz
highEdge	float	parameter	0	8000	0:16000	Hz
centerFreqs	float*	parameter	0	[1 x 10]	20:16000	Hz

Pins

Input Pins

Name: in

Description: Audio Input

Data type: float

Channel range: Unrestricted

Block size range: Unrestricted

Sample rate range: Unrestricted

Complex support: Real

Output Pins

Name: out

Description: Audio output

Data type: fract32

Scratch Pins

Channel count: 1

Block size: 32

Sample rate: 48000

MATLAB Usage

File Name: graphic_eq_subsystem.m

 SYS=graphic_eq_subsystem(NAME, NBANDS, ORDER, HP)
 Creates a multi-band graphic EQ subsystem constructed as a cascade
 of individual sections.  Each section is realized as a
 graphic_eq_band_module.m.  Arguments:
    NAME - name of the module.
    NBANDS - number of bands.  By default, NBANDS=10.
    ORDER - order of each filter section.  This must equal 4, 8, or 12.
            By default, ORDER=8.
    HP - determines whether or not to use high precision versions of 
         the filters (default=0).

GraphicEQ