Overview

One shot player with trigger pin

Discussion

WAV file player in which playback is triggered via an input pin. The input .trigger is a Boolean value which, if set, starts playback. The trigger must be an impulse of length 1 frame, or the initial frame of the WAV will be repeated while .trigger remains set. When .trigger is reset to 0, playback continues from the second frame until it stops at end of the file. If .trigger is set again while in the middle of playback then playback will restart.

The second input pin fRatio determines the playback speed. If fRatio = 1.0 then playback is at the expected rate. fRatio > 1.0 causes the pitch to increase and fRatio < 1.0 causes the pitch to decrease.

The module supports only mono playback and first channel of the input wave file is used if it is a multi-channel wave file.

Type Definition

-Not Shown-

Variables

Properties

Name	Type	Usage	isHidden	Default value	Range	Units
wavLength	int	const	0	100400	Unrestricted
wavSR	int	const	0	48000	Unrestricted
nRate	float	const	0	1	Unrestricted
mRate	float	const	0	1	Unrestricted

Pins

Input Pins

Name: trigger

Description: Boolean trigger signal

Data type: int

Channel range: 1

Block size range: 1

Sample rate range: Unrestricted

Complex support: Real

Name: fRatio

Description: Specifies the playback speed

Data type: float

Channel range: 1

Block size range: 1

Sample rate range: Unrestricted

Complex support: Real

Output Pins

Name: out

Description: Output audio

Data type: fract32

Scratch Pins

Channel count: 1

Block size: 1

Sample rate: 48000